Fast, Reliable Heating & Furnace Across Uptown
Furnace repair in Uptown typically runs $150-$700, with most calls answered by a live person and same-day service available throughout the 60640 ZIP code. Our Heating & Furnace technicians know the neighborhood’s 1920s-1940s courtyard buildings, six-flats, and vintage masonry structures - the kind of housing stock where a “standard” boiler replacement rarely exists. If your heat is out on a cold night along Sheridan Road or your radiator’s banging through a courtyard building in the heart of Uptown, call (833) 983-1671. A real person will pick up, 24 hours a day, and we’ll give you a straight answer about when we can be there and what it will cost.
We’ve worked in Uptown for over 42 years. Terry Kowalski started Fireside Heating & Air Co. in 1984, and our trucks have been navigating the tight streets around Wilson Avenue, Broadway, and the lakefront ever since. We know the difference between a two-pipe steam system in a 1910s courtyard building and a post-war single-pipe conversion in a 1940s six-flat - because we’ve repaired and replaced both, dozens of times, in buildings just like yours.
Why Fireside Heating & Air Co. of Chicago Is Uptown’s Preferred Heating & Furnace Company
Uptown homeowners call us back. They tell their neighbors. In a neighborhood where people stay put for decades - where the same family might own a six-flat for two generations - that kind of reputation is earned one job at a time. We’re not the cheapest bid, and we don’t try to be. We’re the bid you make once and never revisit.
Our response time to Uptown is typically under 90 minutes for no-heat emergencies, faster than most because our Chicago base keeps us close to the 60640 corridor. We don’t send a dispatcher from the suburbs who has to look up Sheridan Road on GPS. Our technicians know that the lake-effect wind chill along the eastern edge of Uptown, especially in the high-rises and flat-roofed vintage buildings facing Lake Michigan, pushes heating systems harder than inland blocks. That local knowledge changes how we diagnose pressure switches, draft inducers, and heat exchanger stress.
Every technician we send is background-checked, uniformed, and trained as a journeyman. They put on shoe covers without being asked. They treat your home, and your tenants’ homes, the way they’d treat their own mother’s. That’s not a slogan - it’s the standard Terry Kowalski set when he started this company, and it’s the standard we still apply on every Uptown call.
Our 90-Day Done Right Promise backs every repair and replacement in writing. If it’s not done right, we make it right. No paperwork, no arguing, no runaround. In a neighborhood full of occupied multi-unit buildings where a botched heating job displaces families, that guarantee matters.
Our Heating & Furnace Services in Uptown
Furnace Repair
A furnace going out in January along Broadway isn’t an inconvenience - it’s an emergency. We repair gas furnaces, steam boilers, and forced-air systems throughout Uptown, from courtyard apartments near Argyle Street to vintage six-flats off Wilson Avenue. Most repairs are completed in a single visit because our trucks carry parts for Carrier, Trane, Lennox, and Goodman systems. A typical furnace repair in Uptown runs $150-$700 depending on the part and the access (tight basement mechanical rooms in century-old buildings add time, and we quote that upfront).

Furnace Replacement
Here’s where Uptown gets complicated - and where our experience pays off. Many 1920s-1940s courtyard buildings still operate original two-pipe steam systems with idiosyncratic piping modifications from past DIY zone additions, making each boiler replacement a custom job that requires tracing the entire loop before any equipment is chosen. We’ve walked into buildings where three different owners over fifty years had each “improved” the zoning, leaving a tangle of abandoned lines, mismatched valves, and ghost thermostats. We map it all. Then we quote a replacement that actually works with what you’ve got - or we tell you honestly when the piping needs to be rethought. Furnace and boiler replacement in these structures typically runs higher than suburban jobs due to access constraints and custom piping, but we’ll give you a firm number before any work begins.

Furnace Tune-Up
Our $89 Seasonal Tune-Up is built for Uptown’s older equipment. We check heat exchangers for cracks from decades of thermal cycling, test gas valves and thermocouples on legacy systems, and inspect for the specific corrosion patterns we see in lakefront buildings where salt air accelerates wear. For steam systems, we verify venting, check water level controls, and look for the telltale signs of single-pipe conversions done wrong. A tune-up in Uptown isn’t a checklist from a manual - it’s a diagnostic tailored to equipment that’s often twice as old as the technician working on it.

Heat Exchanger Repair & Replacement
Cracked heat exchangers are the failure mode we watch for most closely in Uptown’s original cast-iron boilers. Decades of thermal stress in masonry buildings - where the thermal mass of brick slows temperature changes and creates longer heating cycles - fatigues cast iron differently than in frame construction. We test every heat exchanger we access with combustion analysis and visual inspection. If it’s cracked, we red-tag the unit and walk you through replacement options, including whether a modulating boiler or a switch to forced-air with ductless mini-splits makes sense for your building’s layout and budget.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Uptown
We carry parts and factory training for nine major brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. In Uptown, we most commonly encounter Carrier and Trane furnaces in post-1980s conversions, Lennox systems in lakefront high-rise mechanical rooms, and Goodman units in recent landlord replacements. Our warehouse stocks the ignitors, gas valves, control boards, and blower motors that fail most often in Chicago’s heating season, which means most Uptown repairs don’t wait on parts. When a vintage system needs a component that’s no longer manufactured, we’ll tell you straight and pivot to a replacement quote rather than string you along with obsolete scavenger hunts.
Common Heating & Furnace Problems We See in Uptown Homes
- Cracked heat exchangers in original cast-iron boilers. The thermal mass of Uptown’s masonry buildings creates longer, slower heating cycles that stress cast iron over decades. We find this most often in 1920s-1940s six-flats where the boiler has never been replaced. It’s a safety issue - cracked exchangers can leak carbon monoxide - and we red-tag without hesitation.
- Frozen or burst pipes in uninsulated attic and basement runs. Uptown’s eastern edge along Lake Michigan gets hit harder by wind chill than neighborhoods even a mile inland. We’ve responded to burst hydronic lines in basement ceiling chases and attic distribution runs where the original 1910s insulation has settled to nothing. Prevention beats emergency repair every time.
- Failed thermocouples and gas valves on legacy single-pipe steam conversions. Many Uptown buildings were converted from two-pipe to single-pipe steam in the 1950s-1970s, often with DIY zone modifications that added electrical controls the original system never anticipated. The result: gas valves that cycle too frequently, thermocouples that foul from incomplete combustion, and pilot systems that fail on the coldest nights.
- Accelerated compressor and condenser corrosion on lakefront rooftops. For buildings with combined heating-cooling systems or heat pumps, the sustained lake winds along Sheridan Road and the lakefront high-rises pull salt air across rooftop equipment year-round. We see condenser coils and compressor housings deteriorate two to three times faster than comparable inland installations.
Pricing for Heating & Furnace in Uptown, IL
We don’t do mystery pricing. The number we quote is the number you pay.
| Service | Typical Range in Uptown |
|---|---|
| Furnace Repair | $150-$700 |
| Furnace Tune-Up | $80-$200 |
What moves a repair toward the higher end? Access difficulty in tight basement mechanical rooms, after-hours emergency calls, and the complexity of legacy systems where we have to trace modified piping before we can diagnose. For replacements, Uptown’s masonry multi-units often require custom piping, crane or rigging access for rooftop equipment, and coordination with building management - all of which we itemize in our upfront quote, never as surprise add-ons.
We offer $50 off any repair over $250, a free second opinion on any written estimate you’ve received, and a permanent 5% discount for seniors and veterans. Our $89 Seasonal Tune-Up is the best prevention money we know of. Call (833) 983-1671 for a free estimate - we’ll look at your system, explain what we find, and quote a firm number you can take to your board, your partner, or your own pillow.
We Also Serve Cities Near Uptown
Our Heating & Furnace in Uptown service area extends to North Center, Edgewater, Albany Park, and Lincoln Square. The same technicians who know Uptown’s courtyard buildings and lakefront conditions work these adjacent neighborhoods regularly. If you manage properties across multiple ZIP codes, one call to (833) 983-1671 covers them all with consistent pricing and the same 90-Day Done Right Promise.
Serving Uptown, IL - Our Local Coverage Area
We’re based in the Uptown area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Heating & Furnace in Uptown
Uptown’s 1920s-1940s courtyard buildings and six-flats were built with original two-pipe steam systems, but many were converted to single-pipe in the mid-20th century and then modified again with DIY zone additions by subsequent owners. Lincoln Park’s housing stock includes more single-family homes and later construction with less layered modification history. In Uptown, we trace each building’s unique piping evolution before quoting any work. Call (833) 983-1671 and we’ll walk you through what your system actually is - no charge for the conversation.
Yes, and ductless mini-splits are usually the practical path. Uptown’s masonry six-flats have no wall cavities for ductwork and no attic space to speak of. We’ve installed Daikin and Mitsubishi mini-split systems with linesets snaked through existing chases and discreet exterior mounting on courtyard-facing walls. The cost runs higher than a standard suburban install, but it’s achievable without structural modification. Call (833) 983-1671 for a free assessment of your specific building layout.
The banging is almost certainly water hammer in a steam system, not wind - though Uptown’s lakefront wind chill does push your system to cycle more frequently, which makes the hammering more noticeable. Steam condensate isn’t draining properly back to the boiler, often because of incorrect pipe pitch or failed steam vents from the building’s settlement over a century. We see this constantly in Sheridan Road buildings. It’s fixable, not a replacement-level problem, but it needs a tech who understands steam. Call (833) 983-1671 - we’ll quiet it down.
Three to five days for most Uptown multi-unit buildings, assuming we don’t hit buried surprises in the piping. We recently answered a no-heat call on a 1930s six-flat along Sheridan Road. The building had a single-pipe conversion from an original two-pipe steam system, with a 1960s gas-fired boiler that had a cracked section. After tracing the convoluted piping - including an abandoned zone added in the ’70s - we retrofitted a new modulating boiler and added ductless mini-splits for cooling, working within the brick-walled, no-duct structure. Coordination with tenants for brief water shutoffs adds a day compared to a single-family home. We schedule around your occupants and communicate clearly - no one likes a cold apartment with no warning.
Usually not, if the heat exchanger is cracked or the burner assembly is obsolete. A 1950s furnace in Uptown has already outlived two design lifespans, and parts availability is dwindling. That said, if the issue is a failed thermocouple, gas valve, or blower motor and the heat exchanger tests sound, a repair can buy you two to five years. We’ll give you straight talk about repair versus replace, with real numbers for both paths. No pressure - just the facts, and our recommendation based on what we’d do in our own building. Call (833) 983-1671 for that conversation.
Ready to get your heat fixed right? Call Fireside Heating & Air Co. at (833) 983-1671. A live person will answer - day, night, weekend, or holiday - and we’ll schedule your free estimate at a time that works for you. We’ve served Chicago and Uptown for over 42 years, and we’re not going anywhere.
Written by Terry Kowalski, Owner at Fireside Heating & Air Co., serving Uptown and Chicago since 2018.